EN
FR
PT
AR
At present, floor tiles are installed on the ground of many families. Compared with wood floors, floor tiles are better for cleaning and maintenance, so they are called the first choice of families. However, after a long time of use, it will be found that the floor tiles are loose. If you don't pay attention, you will trip up, which is very dangerous. So what can you do with loose floor tiles? How to repair the loose floor tiles? In this guide, Hanse will introduce best loose floor tiles repairing methods.
How To Fix Loose Floor Tiles
1. If the loose area is large, it is necessary to take out all the loose tiles and clean the base course. Then reapply cement mortar through the correct paving method, and pave bricks according to the correct process. Then gently tap with a rubber hammer to make it completely consistent with the ground. At the same time, check the flatness.
2. If the loose area of the floor tile is not very large, you can choose not to remove it, otherwise the whole tile will be damaged. First, determine the same model, knock it out from the center of the floor tile, take out the floor tile, select a new floor tile, and clean the surface with cement mortar or tile glue before paving again. Do not walk on it until it is completely dry, and do not drain water.
Best Methods To Repair Loose Floor Tiles
1. Repair tips for semi loose state
If the floor tile is half loose, you should first find out what caused the problem. If it is damaged, we should replace it in time. The best way is to break the broken tile from the middle, and then carefully pry it open. Only in this way will it not cause unnecessary damage to the surrounding tiles, And we can handle it according to the suggestions of professionals. Another repair method is to use grouting. You can mix 108 glue cement slurry to penetrate it through the cracks of the bricks, but this method can only alleviate the problem. It can not completely solve the problem. The problem of looseness may still occur after a long time. Therefore, it is recommended that you do not walk on the bricks before they are completely dry, and do not leave until they are completely dry.
2. Repair tips for completely loose state
If there is a completely loose state, it is much easier to solve than the semi loose state. Take down the whole brick directly, and then find a new floor tile to paste it. Pay attention to clean the dust and impurities on the ground before pasting, and apply the glue evenly when pasting, so as to avoid bulging after pasting.
The above is a wonderful introduction to the repair of loose floor tiles. When we deal with loose floor tiles, we need to judge the size of the loose area, because there are different solutions to the loose floor tiles. If the floor tiles are loose in a large area, it is recommended to pave them again.
16
