Floor tile is a type of ceramic/porcelain tile which is purchased in the process of home decoration. This kind of floor tile has good quality and long service life. As we know that laying of floor tiles cannot be separated from cement and sand. Only if the two materials match well, can we successfully complete the laying of floor tiles. Then do you know the specific construction method and material ratio during construction? What is the standard mix ratio of sand/cement for floor tiles? The following content will have a good reference value for everyone to understand this problem of tilling floor.

Cement Sand Ratio For Floor Tile - What Is Ratio Of Cement To Sand For Floor Tile Installation

The ratio of cement & sand is 1:2, which conforms to the relevant national regulations. If there is a large proportion of cement, it can be more cohesive, and the ratio of 1:1 can be used when laying wall tiles, but this will increase the cost. Therefore, the cement should be prepared sufficiently in advance. When installing the floor tiles, we can increase the ratio of the two materials to 1:2 or 1:3. That is because most of the floors need to be leveled with cement and sand, so we can not use too much cement to fix the floor tiles.

1. The cement sand ratio of floor tiles is a question left over by history, and there is no accurate data. From the theoretical analysis, the cement sand ratio of floor tile is simple, but there is no specific quantity. Because the base surface sometimes varies, so the cement sand used for tiles flooring will be different.
2. For example, the sand mortar for large format floor tile needs to be plastered with thick points, which is better for laying, so more sand is needed. The normal thickness is generally 30-40mm, and the minimum can not be less than 25mm. The best thickness is 40mm. Small floor tiles are the same, although the area is small, but of course, it is not too thin. According to the empirical calculation method, the sand is calculated as 40 thick x ground area, and the cement is calculated as 0.2 generations per level.
3. Another answer is that, the ratio of cement and sand for floor tiles is about 1 bag of cement and 6 bags of sand. Sand consumption algorithm: for example, to pave 80 square meters of floor, paving 1 meter thick requires 80 cubic meters of sand. The algorithm is 4 × 5 = 20 (square) × 0.05 = 1 cubic of sand.

Floor Tiles Installation Tips

1. Soaking floor tile in water

Because there are many small voids in the floor tile, these gaps have a certain degree of water absorption. If the floor tile is not soaked in water, it will absorb the water in the cement, resulting in voids between the tile and the cement, resulting in hollowing and falling off of the tile floor.

2. Ground leveling

Before we lay the floor tiles, we also need to level the ground, it is best to use cement mortar to smooth the ground, so as to reduce the appearance of tile hollowing phenomenon.

3. Leave a seam

When we install floor tiles, it is best to leave a certain gap between each floor tile to avoid the edge warping phenomenon caused by thermal expansion and cold contraction of the tile. If the gap between the floor tiles affects the beauty, it can be filled with a joint filler to make the tile more beautiful.

The above content mainly introduces the proportion of cement and sand for floor tiles. In the process of laying floor tiles, the matching of cement and sand must be in place. If the laying materials are not matched well, the effect after installation is certainly not very good. Anyway, the sand & cement ratio for floor tiles should be determined according to the specific construction situation. These relevant data presented above can be used in construction.